It seems that RW is not closing multiple connections after opening a new one to upload the next file. My server is blocking me from uploading until those idles connection is dropped because RW is creating too many idle connections.

Did some more testing. Looks like 8.1.7 was closing the connections so it must be a later version that started to show this. The current version is leaving connections open. I’ll leave it to other to sort out. I have to feed the Spaniels.

Thank you for confirming and narrowing it down. Hopefully, we see a fix soon …

Since it’s freezing here and blowing a gale on an otherwise fine autumn morning I tested each version from 8.1.6 to the current. Unfortunately (or may be fortunately) I could not reproduce the problem. I do note, however, that my publishing set up is set to 6 (Lightning fast) SFTP. In 8.1.6 it conn…

I know for sure if your host uses cpanel, you are going to see this issue …

I’ve run into the same problem with RW 8.6.2 on cPanel (v84.0.22). In cPanel>Resource Usage you can see the NPROC (number of processes within LVE) increasing on each successive connection and not resetting between connections. Eventually I can no longer connect via SSH/SFTP. If I quit RW before th…

Well, the reply from Realmac has been to suggest this is a problem with my hosting and not RapidWeaver: “In some cases, hosts simply do not like multiple/concurrent connections to their servers from FTP programs or RapidWeaver.” They then go on to suggest I might might want to look for another hos…

Thank you. My clients use either 1&1 Ionos or Strato. I think these are the largest hosters and both show this lag. After a time transmitting, more connections are opened, but it takes a long time for the initial connection to be established. I think it might be hard to tell these hosters to switch/…

Jan, just replied to your email - can you resend your logs? The attachment didn’t come through. We’ll get this resolved for you as quickly as possible!

Hi, This is correct, some hosts simply do not play well with multiple connections. Each host has a different setup/preference and the key is to find the settings in RW that work best. You mentioned less connections results in a successful publish, but it does take longer - this was where my suggest…

Hi I have the same problem when doing a full upload, My IP was blocked after unblocking I started uploading again and my IP was blocked again. I did not have this problem before updating rapid weaver

RapidWeaver Elements Forum

Are RW closing FTP closing multiple connections after uploading?

RapidWeaver Classic